Craftsman Lt2000 Drive Belt Diagram – mower deck belt replacement

Posted on

Lower the battery in to the mower body and align the particular wire harness and battery wires.. Connect the blade clutch system cable spring to the idler equip..

Craftsman Lt2000 Drive Belt Diagram – Remove the bottom drive cover installation screws. Remove the debris shield installation bolts and pull off the particles shield. Roll the drive belt off the crankshaft pulley, toward the particular engine. Pull the crankshaft pulley off and free the belt from the crankshaft. Release the grip from the mower handle and cheaper the mower to the upright place.
Route the belt through the chassis and over the guiding plate. Push the belt with the inside of the front belt guides.

Craftsman Lt2000 Drive Belt Diagram

Craftsman Lt2000 Drive Belt Diagram

Craftsman Lt2000 Drive Belt Diagram

Step 18: Substitute the lower transmission belt

Craftsman Lt2000 Drive Belt Diagram. Remove the front side lift link support retaining pin number and washer and then detach the particular support from the deck. Remove the still left suspension arm retaining clip and detach the arm from the mower frame. Remove the left rear outdoor patio bracket retaining clip and washing machine and then release the bracket from your deck.
Position the battery package in the opening and engage the particular retaining tabs. Reconnect the seat change wire harness clip to the chair bracket. Lower the battery in to the mower body and align the particular wire harness and battery wires.
The initial step to replacing a ground generate belt is to turn the combustion switch off and remove the key. Raise the mower hood and detach the spark plug wire. Move the blade belt off the motor pulley and release the belt from the belt keepers.

Craftsman Lt2000 Drive Belt Diagram

Craftsman Lt2000 Drive Belt Diagram

Craftsman Lt2000 Drive Belt Diagram

Craftsman Lt2000 Drive Belt Diagram

Belt diagram for drive belt LT2000 model 247. 288843. Connect the blade clutch system cable spring to the idler equip. Push the blade clutch cable connection retainer into the deck bracket plus engage the locking tabs. Reunite the front lift link support towards the deck using the washer and keeping clip.
Release the seat change wire harness clip from the chair bracket. Release retaining tabs plus lift the battery box out from the mower body. Release the generate belt from the transaxle pulley. Cycle the ground drive belt over the transaxle pulley.